Energy Solutions electricians servicing a standby generator
Whole-house generator in Dallas, OR

Dallas: lose the grid, keep the whole house on

Licensed electricians install and permit Generac whole-house standby generators in Dallas. When the grid fails, it starts itself.

5.0 on Google | 106 reviews | CCB 202002

Get a free quote

Step 1 of 2

What you need and how to reach you
What can we help with?

No obligation. We call you back.

Got it. Thank you.

Grant or someone on the team calls you back during business hours: Mon-Fri 8-5:30, Sat 8-12.

Need us sooner? Call (971) 526-5545.

What a whole-house generator does

A standby generator in Dallas is the set-it-and-forget-it answer to long outages. It senses the failure and starts without you. An automatic transfer switch is the brain of the system. It senses the outage, isolates your house from the grid, and starts the generator for you.

These are permanent Generac standby units, not portables, matched to the loads you want covered.

What stays on during an outage

  • Protection: medical equipment and sump pumps keep working.
  • Heating and cooling: furnace, heat pump, or air conditioning.
  • Food and chores: refrigerator, freezer, range, and washer.
  • Lights and electronics: lighting, TVs, computers, and the home office.

Generator size and panel capacity decide what can run together. We sort that out with you at the free quote.

Natural gas or propane

Around Dallas, you have two fuel choices: natural gas or propane. A home already on natural gas can connect the generator directly to the line. No gas line? Propane from a tank installed for the generator works anywhere.

Either fuel gives you a permanent system with no manual starting.

Permanent or portable power

If you live in Dallas, portable units need you to set them up in the dark and the rain. A standby generator is permanent and takes over automatically.

Whole-home coverage is what a standby generator is built for, and we size it so the circuits you care about in Dallas stay on together.

Before anything is ordered, we agree with you on where it goes, what it runs on, and how big it is.

From quote to standby power

Installing a standby generator in Dallas takes four steps, from a free consultation through permit and install to activation.

  1. Consultation and design: we plan the size and placement together.
  2. Permitting and paperwork: we pull the Oregon permit.
  3. Installation: fuel line or propane tank, transfer switch, and wiring.
  4. Activation and support: we commission it and stay available after the job.

A backup generator needs a permit in Oregon, and we pull it for you.

Because we are licensed electricians, the transfer switch, the wiring, and the panel review all stay with one team.

Natural gas and propane generators both work, and we help you choose the one that fits your home. A home battery needs no fuel; a generator runs as long as it has fuel.

Every service we offer in Dallas

We bring every one of our services to Dallas, so one licensed team can handle the whole project.

Whole-house generator near Dallas, Polk County

Dallas sits in Polk County, and our whole-house generator work covers the county and the cities around it. Energy Solutions is rated 5.0 on Google across 106 reviews.

Not in Dallas? We do the same work in Rickreall, Monmouth, Falls City. All locations are on our service area page.

In Dallas we also install a home battery.

The quote is free, and we check every incentive that may apply, including Energy Trust of Oregon and state programs. The federal homeowner credit has ended, so we tell you straight what is available.

Have questions first? Call (971) 526-5545 or Request a free quote.

Questions we hear a lot

Do I need a permit for a backup generator in Dallas?

Yes. Oregon requires a permit for a backup generator, and we pull it for you.

Does a standby generator run on natural gas or propane?

Either. If your home has a natural gas line, the generator can connect to it. If not, propane from a dedicated tank works.

Does the generator start by itself?

Yes. An automatic transfer switch detects the outage, switches your home over, and starts the generator, then switches back when the grid returns.

Will my panel work with a generator?

We look at your panel during the free quote and tell you if it needs attention before the generator goes in.

Nearby areas we serve