Energy Solutions electricians servicing a standby generator
Whole-house generator in Hubbard, OR

Hubbard: whole-house power, and we pull the permit

Licensed electricians install and permit Generac whole-house standby generators in Hubbard. When the grid fails, it starts itself.

5.0 on Google | 106 reviews | CCB 202002

Get a free quote

Step 1 of 2

What you need and how to reach you

No obligation. We call you back.

Got it. Thank you.

Grant or someone on the team calls you back during business hours: Mon-Fri 8-5:30, Sat 8-12.

Need us sooner? Call (971) 526-5545.

Automatic power for your Hubbard home

A standby generator in Hubbard is the set-it-and-forget-it answer to long outages. It senses the failure and starts without you. A transfer switch handles the handoff: it moves your home from the grid to the generator and back again with no manual steps.

The generators we install are Generac standby units. They are permanent, hard-wired to your home, and sized to the loads you need covered.

Loads worth covering

  • Food and chores: refrigerator, freezer, range, and washer.
  • Everyday power: lights, TVs, computers, and work gear.
  • Critical equipment: medical devices and sump pumps.
  • HVAC: furnace, heat pump, or air conditioner.

At the free quote we add up the loads and pick a generator size that fits them.

Choosing your fuel

Around Hubbard, natural gas or propane: those are the two options, and we help you pick the one that suits your property. No gas line? Propane from a tank installed for the generator works anywhere.

Once it is in, there is nothing to carry, pour, or start by hand.

Standby or portable generator?

If you live in Hubbard, with a portable generator you do the work during the outage. With a standby generator, the system does it for you.

If you want the furnace, the kitchen, and the home office all on at once, a standby generator sized for your loads is how that happens in Hubbard.

We walk you through placement, fuel, and size at the free consultation, so the plan is clear before anything is ordered.

What happens after you call

The path to standby power in Hubbard is four steps: design, permit, installation, and commissioning.

  1. Consultation and design: a free visit to look at your loads, your panel, and where it will sit.
  2. Permitting and paperwork: the permit and paperwork are ours.
  3. Installation: our electricians set the unit, connect the fuel, and wire the transfer switch.
  4. Activation and support: we test it, show you how it works, and support you afterward.

Oregon requires a permit for a backup generator, and we file it for you.

Generator work is electrical work first. We tie the transfer switch into your panel, so our licensed electricians do the install and look at your panel during the free quote to see whether it needs attention.

Want to compare options? A home battery is quieter and needs no fuel, while a generator keeps running as long as it has fuel.

Every service we offer in Hubbard

All of our services are available to Hubbard homes and businesses, from solar to EV chargers.

Whole-house generator near Hubbard, Marion County

Hubbard sits in Marion County, and our whole-house generator work covers the county and the cities around it. Customers rate us 5.0 on Google, across 106 reviews.

Nearby cities where we do the same work: Woodburn, Aurora, Gervais. All locations are on our service area page.

In Hubbard we also install a home battery.

The quote is free, and we check every incentive that may apply, including Energy Trust of Oregon and state programs. The federal homeowner credit has ended, so we tell you straight what is available.

Next step: Request a free quote or call (971) 526-5545 to talk it through.

Questions we hear a lot

Do I need a permit for a backup generator in Hubbard?

Yes. Oregon requires a permit for a backup generator, and we pull it for you.

Does a standby generator run on natural gas or propane?

Either. If your home has a natural gas line, the generator can connect to it. If not, propane from a dedicated tank works.

Does the generator start by itself?

Yes. An automatic transfer switch detects the outage, switches your home over, and starts the generator, then switches back when the grid returns.

Will my panel work with a generator?

We look at your panel during the free quote and tell you if it needs attention before the generator goes in.

Nearby areas we serve